Product details
Rod Holders keep your fishing rods organized and out of the way while in the kayak or boat, allowing you to have more than one rod ready to go at a moment's notice. Aside from fishing rods, you can use the rod holders for a net, flag pole, light pole, camera pole, or other pole products you need to place in. Used on console for fishing rods storage, or on deck edge for fishing.
KA2 30 Degree Flush Mount Rod Holder features a 30-degree design, which is the most common angle for Fishing Rod. Also, the 30-degree helps angle the rod farther away from your boat, which is good for bottom fishing. With the sealed bottom, you can place your fishing rods well without any worries! The hollow bottom design ensures water can pass through the holder, preventing water accumulation from damaging your fishing rods or equipment.
Made from plastic ABS, standing up to outdoor conditions for a long time.
The Rod Holder needs a 4.5×3.5 inch flat deck area, and the space under the deck needs to be more than about 9 inches deep to accommodate the 30 degree angled mounting. And the hole at the rod holder bottom is divided into two, with a width of approximately 18.6mm of each.
To strengthen the seal and ensure the waterproof function, you can add KA22 30 Degree Flush Mount Rod Holder Gasket for your Rod Holder.
In addition, if you also want to ensure that water or debris will not enter the Rod inside,
KA20 30 Degree Flush Mount Rod Holder Cap Cover Gasket
can meet your needs.
At some point you might don’t want the bottom of the Rod to be hollow, you can add KA6 Rod Holder Cap on to seal the bottom for you.
Kindly choose the right Rod Holder that suits the size or style you need for your kayak or boat.
*Instructions and mounting hardware are not included.
Recommend Fasteners for Rod Holders:
- BP-416 Kayak Pad Eyes
- KC2 Rivets
- M6 or #1/4" Screws
- Screw Nut
- Well Nut
*Kindly choose the right length of the fasteners based on kayak material or nut-sert.
Other Rod Holders Series Products:
- KA1 30 Degree Flush Mount Rod Holder - Sealed Bottom
- KA3 0 Degree Flush Mount Rod Holder - Sealed Bottom
- KA5 Fishing Rod Tube with Stand-Off
- KA5-2A & KA5-2B Two Pole Deck Mount Rod Storage Rack
- KA5-3A & KA5-3B Three Pole Deck Mount Rod Storage Rack
Specification
| Product No. | L(mm) | W(mm) | H(mm) | Hole Size(mm) | Bottom Hole Size(mm) | Screw Hole Size(mm) |
| KA2 | 114.30 | 88.90 | 245.10 | 51.0 | 18.60 (each) | 5.80 |